T&S Industries, Inc.    

                                                                                                                                                                                                    
Home Feedback                                                                       

 

Web Changes

This is where we announce the most recent additions to our web site. If you've visited us before and want to know what's changed, please take a look here first.

For 2007, our T&S Shell Catchers are made for the following guns:

The NEW Beretta Shell Catcher with INTEGRATED ACTION RELEASE LEVER is now available.  (Stk, No. TS-391L)  Please visit the Beretta Products section of our web site.

We recently made a special run of the original T&S Shell Catcher for the Winchester Super X Model 1 12 Ga Trap gun.  (This shell catcher will NOT fit ANY OTHER MODELS.)  We have some of these available WITHOUT a modified bolt handle.  A modified bolt handle is required if the catcher is to be used with a bolt handle in place.  A sketch of instructions is included with each order, so the consumer can have his/her bolt handle modified by a competent machinist or gunsmith so it will clear the T&S Shell Catcher.  Because we have no control over this modification, we cannot be responsible for any problems resulting from this modification.  Many of the Winchester Super X Model 1 Trap guns in use, already have such a modified handle (groove in the bottom side of the handle) installed because they may have been used with one of the original T&S Shell Catchers over 20 years ago.  This shell catcher may not work with all Winchester Super X Model 1 Trap guns because of receiver variations.  If you purchase one and it does not allow the bolt to close with a modified bolt handle, it may be returned in it's original condition for a refund (less shipping costs).  This T&S Shell Catcher, Stk. No. TS-SX1, is only available directly from T&S Industries, Inc. (our address is located elsewhere on this web site) because of the need to explain the modification.  When ordering by mail, the TS-SX1 cost is $19.95 plus $2.00 Shipping & Handling via First Class U.S. Mail.  

Winchester Super X Model 1 - 12 Ga   Super strength plastic with steel insert TS-SX1
 		$19.95

 

 

[ Home ]

Copyright © 2002 T & S Industries, Inc.
Benelli™ is a registered trademark of Benelli USA.  Beretta™ is a registered trademark of Beretta USA.  Browning™ is a registered trademark of Browning.  Remington™ is a registered trademark of Remington Arms Co.  Ithaca™ is a registered trademark of Ithaca Gun Co.  SKB™ is a registered trademark of SKB Shotguns.
Last modified: 06/02/08